The Tone Generator/Cable Tester is the main testing unit and is used to test cable continuity for Coaxial cables, RJ45 and RJ11 cables, and for individual wires using the attached alligator clips. Each unit is powered by a 9 volt battery and two batteries are included in the packaging. Each unit is constructed of plastic with the edges covered in rubber to improve grip. The tester is composed of two main units: the Tone Generator/Cable Tester and the Amplifier Probe with sensing tip. It can also be used to trace and identify individual wires within a wire bundle or group and can provide talk testing functionality between telephone units. The 3-in-1 Tracer/Toner/Cable Tester is a professional tool used to test and troubleshoot RJ45, RJ11, and BNC cables. Try different locations and you will find what you are looking for.RJ-45, BNC, and Speaker Wire Tone Generator/Tracer/Tester To test and troubleshoot RJ45, RJ11, and BNC cables Tone up the plumbing metal lines by attaching the device's lead into the water pipe. Sweep the detector on the floor and wait till you hear the bit's exact location. After you drill through a wall clip the lead of the generator to the drill bit. Step 11 – Drill Bitsįind the accurate wall cavity by using this tool. The tone probe will help in isolating the telephone wire from the other wires at the junction box. Connect the device to a telephone jack and turn it on. You can locate the telephone lines using the tone generator. If you hear a drop in the tone, that implies that the tone generator has found a break in the wiring. Use an amplifier probe to run it through the wire's path. Connect the tool to the wire you wish to trace. Step 9 – Locate BrakesĪnother use of the tone generator is to locate breaks. Clipping it to a dead wire will help you trace the path of the wire. Adjust the generator to the tone position and place the toner beside it. This tool is helpful in tracing wires to their origin. If you hear sounds that are originating from the device, then it implies that the speakers have gone bad. In case your speakers are not working all you need to do is attach this toner to the back of the faulty speaker. The toner function helps to detect any existing signals. If you find a green light, a negative source has been connected to the red lead. A lit LED conveys that the wire that is connected to the red lead is the positive one. You can determine the positive wire by looking at the LED. Take a couple of wires and establish contact with the DC Circuit. This will tone down and turn off the speaker volume. Move the switch on the device to the tone setting. Step 5 – SpeakerĪnother use of the tone generator is to test the speakers in your cars. If the resistor witnesses a waver your light will also waver accordingly. If you turn the switch to the line position, you will be able to measure the resistor. If the LED comes on, that means electricity is passing and that it is a live wire. Now take the leads and establish contact with wires. All you have to do is turn off the switch located on the top. You can check the voltage with the tone generator. Firstly, it is a great aid for electronic equipment testing and, secondly, it acts as a testing device for informational signals that come handy when dealing with telephone systems. There are two main functions of a tone generator. A tone generator is a simple tool that is sometimes used with live and sometimes bare wires, so make sure you have taken precautions to avoid getting shocked.
0 Comments
Leave a Reply. |